A transmitter is an electronic device which, usually with the aid of an antenna, propagates an electromagnetic signal such as radio, television, or other telecommunications.

Transmitter types

In radio electronics and broadcasting, a transmitter usually has a power supply, an oscillator, a modulator, and amplifiers for audio frequency (AF) and radio frequency (RF). The modulator is the device which piggybacks (or modulates) the signal information onto the carrier frequency, which is then broadcast. Sometimes a device (for example, a cell phone) contains both a transmitter and a radio receiver, with the combined unit referred to as a transceiver. In amateur radio, a transmitter can be a separate piece of electronic gear or a subset of a transceiver, and often referred to using an abbreviated form; "XMTR". In most parts of the world, use of transmitters is strictly controlled by laws since the potential for dangerous interference (for example to emergency communications) is considerable. In consumer electronics, a common device is a Personal FM transmitter, a very low power transmitter generally designed to take a simple audio source like an iPod, CD player, etc. and transmit it a few feet to a standard FM radio receiver. Most personal FM transmitters In the USA fall under Part 15 of the FCC regulations to avoid any user licensing requirements.

In industrial process control, a "transmitter" is any device which converts measurements from a sensor into a signal to be received, usually sent via wires, by some display or control device located a distance away. Typically in process control applications the "transmitter" will output an analog 4-20 mA current loop or digital protocol to represent a measured variable within a range. For example, a pressure transmitter might use 4 mA as a representation for 50 psig of pressure and 20 mA as 1000 psig of pressure and any value in between proportionately ranged between 50 and 1000 psig. (A 0-4 mA signal indicates a system error.) Older technology transmitters used pneumatic pressure typically ranged between 3 to 15 psig (20 to 100 kPa) to represent a process variable.

History

In the early days of radio engineering, radio frequency energy was generated using arcs known as Alexanderson alternator or mechanical alternators (of which a rare example survives at the SAQ transmitter in Grimeton, Sweden). In the 1920s electronic transmitters, based on vacuum tubes, began to be used.

Frequency Control

see: Radio transmitter design

Power output

In broadcasting, and telecommunication, the part which contains the oscillator, modulator, and sometimes audio processor, is called the exciter. Confusingly, the high-power amplifier which the exciter then feeds into is often called the "transmitter" by broadcast engineers. The final output is given as transmitter power output (TPO), although this is not what most stations are rated by.