A bicycle helmet is a helmet intended to be worn while riding a bicycle. They are designed to attenuate impacts to the cranium of a cyclist in falls while minimizing side effects such as interference with peripheral vision. There is intense academic debate on whether helmet use offers any reduction of the chance of head injury. The debate on whether helmet use should be compulsory is even more intense and occasionally bitter, often based not only on differing interpretations of the academic literature, but also on differing assumptions and interests on the two sides.

A cycle helmet should be light in weight and should provide adequate ventilation, because cycling can be an intense aerobic activity which significantly raises body temperature and the head in particular needs to be able to regulate its temperature.

History of designs

The first commercially successful purpose-designed bicycle helmet was the Bell Biker, a polystyrene-lined hard shell released in 1975. At the time there was no appropriate standard; the only applicable one, from Snell, would be passed only by a light open-face motorcycle helmet. Over time the design was refined and by 1983 Bell were making the V1-Pro, the first polystyrene helmet intended for racing use. In 1984 Bell produced the Li'l Bell Shell, a no-shell children's helmet. These early helmets had little ventilation.

In 1985 the Snell B85 was introduced, the first widely-adopted standard for bicycle helmets; this has subsequently been refined into B90 and B95 (see Standards below). At this time helmets were almost all either hard shell or no-shell (perhaps with a vacuum-formed plastic cover). Ventilation was still minimal due mainly to technical limitations of the foams and shells in use.

Around 1990 a new construction technique was invented: in-mould microshell. A very thin shell was incorporated during the moulding process. This rapidly became the dominant technology, allowing for larger vents and more complex shapes than hard shells.

Hard shells declined rapidly among the general cyclist population during the 1990s, almost disappearing by the end of the decade, but remain popular with BMX riders as well as inline skaters and skateboarders.

The late 1990s and early 2000s saw advances in retention and fitting systems, replacing the old system of varying thickness pads with cradles which adjust quite precisely to the rider's head. This has also resulted in the back of the head being less covered by the helmet; impacts to this region are rare, but it does make a modern bike helmet much less suitable for activities such as unicycling, skateboarding and inline skating, where falling over backwards is relatively common. Other helmets will be more suitable for these activities.